Energy systems designed in direct current — for homes, buildings and the structures beyond the grid.
We design, engineer and program DC-first solar, battery storage and power distribution. Then we keep it running. The goal is to take each property as far off the grid as it can sensibly go, and to retire the standby generator for good.
One firm accountable for the system, from the first site study to every year it runs.
01
Design & Engineering
Site study, load analysis and a DC-first system architecture for the property. Permit drawings, with PE-sealed drawings where the jurisdiction requires them.
SITE STUDY · ARCHITECTURE · DRAWINGS
02
Equipment
Complete system packages: solar PV, battery storage, DC/DC charge modules, DC power distribution, bidirectional DC-to-AC inverters and the controller that runs them. Listed equipment only.
PV · STORAGE · DC DISTRIBUTION · INVERTERS
03
Installation Coordination
In Nevada, our own licensed electricians install. Everywhere else we coordinate a licensed partner installer, or support the installer you choose, with kits, labeled harnesses and clear documentation.
NV CREWS · PARTNERS · YOUR INSTALLER
04
Programming & Controls
The Aeterna EMS is configured for each site and its utility's rules: bus start-up sequencing, state-of-charge management, load shedding, tariff-aware peak control and remote commissioning.
EMS · TARIFF LOGIC · COMMISSIONING
05
Monitoring & Service
Remote monitoring, alerts, firmware and performance reporting, plus maintenance plans with inspections and battery health testing. Field visits are handled by Aeterna technicians or certified partners.
MONITORING · ALERTS · MAINTENANCE
“Whoever installs it, wherever it sits, every system runs on one architecture, one controls platform and one service organization.”
THE AETERNA STANDARD
E-201 The DC-first approach
Stay in DC. Convert only when you must.
A proprietary architecture, designed in-house.
Solar panels and batteries are DC devices, and so is much of what a modern building runs on. Conventional systems convert back and forth between DC and AC at almost every step. Aeterna ties generation, storage and DC-capable loads to one common DC bus, run by the Aeterna EMS, and converts to AC only for the circuits that still need it.
ONE-LINE · MODE
P/01
Battery first, generator never — or last.
The battery is the heart of every system. Generators are retired, or kept only as a manual last resort.
P/02
Stay in DC wherever practical.
Solar charges storage DC-to-DC. Large DC-capable loads draw straight from the bus. Only legacy AC circuits pass through the inverter.
P/03
Program for the local tariff.
The EMS is configured remotely for each utility's rules — demand charges, netting intervals, time-of-use windows.
P/04
Design to the codes that exist.
Designed around NEC Article 712 for DC microgrids and Article 706 for energy storage systems, using listed equipment.
P/05
Installer-proof by design.
Pre-engineered kits, labeled harnesses and remote commissioning checks so a certified installer gets it right in any state.
P/06
Engineered for uptime.
Controlled bus start-up and pre-charge, over- and under-voltage protection, wired plus cellular telemetry and time-synchronized logging.
E-251 How it works
Follow the power, end to end.
Five steps from sunlight to the lights staying on.
Solar on the roof feeds a DC power cabinet and its common DC bus. The battery bank, DC loads and protected critical loads share that bus, and a bidirectional inverter serves the existing AC panel. The utility connection is optional. Follow the numbered steps, switch modes to see how the power path changes, and drag to look around.
3D MODEL · MODE
Drag to orbit
E-301 Applications
Homes. Buildings. Structures.
One value proposition at every scale: own your power.
RESIDENTIAL
Homes & estates
Whole-home battery backup without a generator, lower bills and peak control. For new builds, a full DC-first design with a DC sub-panel. For existing solar owners, storage and controls added to what you have.
Resilience Core
DC Solar + Storage
Aeterna Off-Grid Estate
COMMERCIAL · MULTIFAMILY
Buildings & portfolios
A DC microgrid on a 380 VDC-class bus for demand-charge management, tenant resilience and uptime, with a multi-site dashboard and one engineering standard across every property in every state.
Commercial / Multifamily DC Microgrid
Aeterna Controls multi-site
Commercial O&M
REMOTE · OFF-GRID
Structures beyond the grid
Ranches, agricultural sites, cabins, telecom and construction sites, anywhere utility service is unavailable or a line extension costs too much. Skid- or container-based power, engineered to run on its own.
Remote Structure Power Kit
Aeterna Off-Grid Estate
E-401 Generator replacement
Silent backup. No fuel. No start-up.
Where full independence isn't practical, the battery replaces the generator.
A fossil-fuel standby generator waits for the power to fail, then starts, then transfers. An Aeterna system is already running. Protected circuits are fed from the DC bus, so when the grid drops, they don't notice.
FactorStandby generatorAeterna battery
FuelGas, propane or dieselSun and storage
On outageStart, then transferAlready online
Critical loadsBrief interruptionNo transfer gap
Noise & exhaustEngine running on siteSilent · none on site
Every other daySits idleSolar storage, peak control
Independence is a spectrum. We engineer each property to the right point on it.
Battery backup, generator retired
Stay connected to the utility, add storage and controls, and replace the standby generator with automatic, silent battery backup for the circuits that matter.
Solar and storage on a shared DC bus carry the property day to day. The EMS uses the grid only when it makes sense under the local tariff, and islands automatically when it fails.
GRID: OPTIONAL · STORAGE: PRIMARY · GENERATOR: NOT REQUIRED
Full autonomy
Generation, storage and DC distribution sized to run the property on its own, season after season, for estates and structures where utility service is absent, unreliable or simply not wanted.
GRID: NONE · STORAGE: SIZED FOR AUTONOMY · GENERATOR: NONE
E-601 Process
From site study to every year after.
01
Site study
Loads, utility tariff, roof and ground area, existing equipment and what independence means for you.
02
DC-first design
System architecture, equipment selection and drawings, PE-sealed where the jurisdiction requires it.
03
Equipment & permits
The full package specified and supplied, with documentation for permitting and interconnection.
04
Installation
Our licensed crews in Nevada; a coordinated licensed partner, or your own licensed installer, everywhere else.
05
Programming & commissioning
EMS configured for your site and tariff, then commissioned and acceptance-tested remotely.
06
Monitoring & care
Continuous monitoring, alerts, firmware, reporting and scheduled maintenance for the life of the system.
DELIVERY · A
Aeterna-installed
In states where Aeterna holds an electrical contractor license — Nevada first. Design, equipment, installation, programming and service from one team.
DELIVERY · B
Certified partner
A licensed local installer we select and coordinate does the field work under its own license. We provide design, equipment, programming, oversight and service.
DELIVERY · C
Your installer
Already have a licensed electrician or contractor? We supply the design, equipment, remote programming, controls and monitoring, and support them through the build.
E-701 Nationwide coverage
Headquartered in Nevada. Built for all fifty.
Central engineering and controls. Local licensed hands.
One engineering and controls platform serves every state. Las Vegas is our headquarters and proving ground. From there, the planned rollout extends to high-value markets, then the Northeast and Midwest, then every remaining state through partners and client-selected installers.
Headquarters · Aeterna-installed
Phase 2 · high-value markets
Phase 3 · Northeast & Midwest
Phase 4 · all remaining states
Planned rollout; timing and partner availability vary by state.
E-801 About
Aeterna — from the Latin for eternal.
Aeterna Energy Group is a DC-first energy design, controls and service company headquartered in Las Vegas, Nevada. Our proprietary Aeterna DC-first system architecture is at the core of every project we deliver.
We are deliberately asset-light: we install with our own licensed electricians where we hold a license, and work through licensed installers everywhere else. That lets one design standard, one controls platform and one service organization stand behind every system, nationwide.
Headquarters
Las Vegas, Nevada
Focus
DC-first solar · storage · controls
Service area
United States
E-901 Consultation
Start with a design consultation.
Tell us about the property. We'll tell you how far it can go.
Homeowners, builders, architects, property owners and installers are all welcome. Submitting opens an email to our team with your details filled in.